BHPC Forum Homepage
Forum Home Forum Home > Public: Open to anyone > Building
  New Posts New Posts RSS Feed - CNCing EPS: endmilling vs hot wire, waste
  FAQ FAQ  Forum Search   Register Register  Login Login

Starting a new topic? Please try and put it in a relevant forum (Riding, Building, etc) but if you're not sure it's better to post in any forum than not to post at all.

CNCing EPS: endmilling vs hot wire, waste

 Post Reply Post Reply
runcyclexcski View Drop Down
BHPC Member
BHPC Member

Joined: 23 May 2017
Location: east midlands
Status: Offline
Points: 57
Post Options Post Options   Thanks (0) Thanks(0)   Quote runcyclexcski Quote  Post ReplyReply Direct Link To This Post Topic: CNCing EPS: endmilling vs hot wire, waste
    Posted: 05 August 2017 at 9:58pm
Hi all --

when you make your moulds, do you hot wire EPS to shape, and then sand? Has anyone tried to make a CNC router to streamline mouldmakin? Would you use a hot wire or a cutter? Hot wire sounds cheaper, but milling could work with more materials. T-slot extrusions, step motors etc can be light duty b.c. foam is so light. Arduino to control it all.

video to illustrate roughly what I have in mind:

Recommendations on where to get large EPS blocks for cheap? On ebay, a full block of EPS 1x1x3 meters comes up to about 200 quid. Not a killer, but feels bad to burn 200 quid for 3 m^3 of fluff. Once I start generating a lot of EPS chips and waste -- is there any good use for it? Not looking to make any money off the waste, just don't wanna dump it on a landfill.

My experiments with balloons sucked: I was restricted to round shapes, and baloons shrunk during curing of polyurea shells.

Edited by runcyclexcski - 05 August 2017 at 10:07pm
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.02
Copyright ©2001-2015 Web Wiz Ltd.